50 Years Munk: Of roots, values and growth
We celebrate 50 Years company anniversary'
Rectifiers in low-floor design
PowerCabinet Nano and PSP 2540
If height is a challenge
PSP Tower: efficient - flexible - sustainable
Surface Technology, Stuttgart
New Date !
Now: 27.-29. October 2020
- 50 Years Munk: Of roots, values and growth
- Rectifiers in low-floor design
- PSP Tower: efficient - flexible - sustainable
- Surface Technology, Stuttgart
compass Click here and you will find your desired DC Power Supply
The over current monitor may only be installed in rectifiers that are employed in modern process engineering in the fields of copper-plating, nickel-plating, chromium-plating, anodising, manufacture of printed-circuit boards and galvanisation.
The overcurrent monitor measures the voltage at the shunt. If the shunt voltage exceeds a set value, a comparator changes over and starts a ramp-function generator. After a certain time delay, the output relay is changed over. If the overcurrent has decreased to a value below the set operating point before the ramp-up time of the integrator has been reached, the ramp-function integrator will be reset and the output relay will not change over. In case of a new over current, this process is started again. If a very high over current occurs, the output will be changed over without the time delay of the integrator.
|Supply Voltage:||230 V / 50 Hz|
|Rated Value for shunt resistor:||60 mV|
|Output Relay 1:||Load Relay 250 VAC 10 A|
|Output Relay 2:||Relay 24 VDC 0,1 A|
|Dimensions (B/T/H):||45 / 70 / 110 [mm]|
|Recommended Setting Range:||50...70 mV|
Article-ID 56953 (standard design)
Article-ID 56963 (with reset button)